HydraPak Seals: Technical Service Request, Step 1

Request Technical Services:

To request technical services, there are 2 steps. Please fill out the form below and then proceed to Step 2. Areas marked "required" must be filled out before you submit your order. A representative will contact you within 24 hours to confirm your request.

Step 1: Technical Specifications
OPERATING CONDITIONS
Static:	Media/Fluid
Rotary:	RPM Direction (from air or low pressure side of seal) CW CCW Oscillatory Rate Oscillatory Degree Dither Rate
Linear/ Reciprocating:	Stroke (units) Rate/Speed Dither Stroke Dither Rate
Friction:	Breakout Running
Pressure (units):	Operating Proof Burst
Temperature (units):	Operating High Low
Bore/Shaft misalignment (T.I.R.):
Shaft Runout (T.I.R.):
Life Requirement:
Allowable Leakage:
Is Seal Installation Tooling Required:	Yes No SGPPL to design SGPPL to supply
HARDWARE
Gland Type:	(see chart below)
Material:	Surface A Surface B
Hardness:	Surface A Surface B
Coating:	Surface A Surface B
Finish:	Surface A Surface B
SKETCH/DIAGRAM
Upload a drawing (8 MB filesize max)

Request Technical Services:

Step 1: Technical Specifications

OPERATING CONDITIONS

Static:

Rotary:

Linear/ Reciprocating:

Friction:

Pressure (units):

Temperature (units):

Bore/Shaft misalignment (T.I.R.):

Shaft Runout (T.I.R.):

Life Requirement:

Allowable Leakage:

Is Seal Installation Tooling Required:

HARDWARE

Gland Type:

Material:

Hardness:

Coating:

Finish:

SKETCH/DIAGRAM

Upload a drawing